Maintenance And Cleaning - TEFAL Prima Plus Bedienungsanleitung

1800119552 FV33XX FTC E0_Passer en 110x154 11/06/10 14:38 Page110
Obtain more steam
• Press the Superpressing button
stubborn creases (
Vertical steam ironing
Ideal for removing creases in suits, jackets, skirts, curtains, etc. :
• Hang the garment on a hanger and hold the fabric slightly taut
with one hand.
• Set the thermostat control to MAX (
• Press the Superpressing
iron from top to bottom (
• Hold the iron a few centimetres from the fabric to avoid burning
delicate fabrics.

Maintenance and cleaning

Cleaning the anti-calc valve
• Unplug your iron and empty the water tank.
• Press the self-clean ejection button (
anti-calc cartridge (
• Soak the valve in a cup of white spirit vinegar or plain lemon juice
for 4 hours.
• Rinse the valve under running water and Replace the anti-calc
valve.
Carry out the self-cleaning operation
To slow down scaling and
prolong the useful life of
your iron, carry out the
self-cleaning operation
once a month.
110
(according to model)
now and again to remove
fig 7
).
• Whether steam or dry ironing, you are able to use the Spray
fig 8
button (
(according to model)
fig 9
button repeatedly (
fig 10
).
• Set the steam control to
• Wait until the soleplate cools down and empty the reservoir.
A little water may remain in the reservoir.
• Wind the cord around the heel of the iron.
• Store the cold iron on its heel (
fig 12a
fig 12b
)
• Unplug your iron, set the steam control to
water reservoir to MAX.
• Place your iron on its heel, set the thermostat button to MAX, plug
in your iron and wait for the indicator light to go out.
• Unplug the iron and place it horizontally over a sink.
• Press the self-clean ejection button (
anticalc cartridge (
• Gently shake the iron over the sink until some of the water (along
with impurities) runs out through the soleplate.
• At the end of the operation, put the anticalc cartridge back in
place and then plug in your iron for 2 minutes on its heel to dry the
soleplate.
Spray Function
) to dampen laundry to remove stubborn creases.
).
fig 7
) moving the
and unplug the iron.
fig 11
(once a month)
) and remove the
fig 12b
).
Wait a few seconds
between each shot before
pressing the button again..
Every fifth time you press
the button, return the iron
to the horizontal position.
The steam is very hot, so
you should always do this
with the garment on a
hanger – never while
someone is wearing it.
Store your iron
).
Unplug your iron and let
it cool down before
cleaning it.
The iron will not function
without the anti-calc
valve. Never touch the
end of the valve !
(once a month)
and fill the
fig 12a
) and remove the