Initial Use - Nova 320600 Anleitung

Congratulations!
You have purchased a Nova product.
Our aim is to provide quality products with
a tasteful design and at an affordable price.
We hope that you will enjoy this product for
many years.
Description (fig. A)
Your 320600 Nova steam iron has been
designed for dry ironing and steam ironing.
The appliance is suitable for indoor use only.
The appliance is suitable for domestic use only.
1. Iron
2. Steam generator
3. On/off button / On/off indicator
4. Temperature control dial
5. Temperature indicator
6. Temperature display
7. Steam volume button
8. Steam volume indicator
9. "Steam ready" indicator
10. "Pump active" indicator
11. Anti-scaling cartridge replacement indicator
12. "Water reservoir empty" indicator
13. Steam shot button
14. Steam lock button
15. Handgrip
16. Steam hose
17. Soleplate
18. Iron holder
19. Water reservoir
20. Water filling point
21. Water drain point
22. Mains cable storage strap

Initial use

• Clean the appliance. Refer to the section
"Cleaning and maintenance".
• To remove contaminants from the
soleplate, turn the temperature control dial
to the 'max' position and iron over a soft,
damp cloth.
Note: If you switch on the appliance for the
first time, the appliance may emit a little
smoke and a characteristic smell for a short
period. This is normal operation.
Use
Filling the water reservoir (fig. B)
Before you proceed, we need you to pay
attention to the following notes:
- Before filling the water reservoir, switch off
the appliance, remove the mains plug from
the wall socket and wait until the appliance
has cooled down.
Before you proceed, we would like you to
focus your attention on the following notes:
- Always fill the water reservoir with water,
even if the steam function is not used.
- Do not exceed the maximum mark ("MAX")
when you fill the water reservoir.
- It is recommended to fill the water
reservoir with a mixture of 50% tap water
and 50% distilled water, especially in areas
with hard water, in order to prevent the
formation of excessive limescale.
- Only use cold water to fill the water
reservoir.
- Do not use carbonated water or other
liquids to fill the water reservoir.
Before use (fig. B1)
• Press the release button (23) to remove the
water reservoir (19) from the appliance.
• Open the cover (24).
• Fill the water reservoir (19) through the
water filling point (20) with water.
• Close the cover (24).
• Place the water reservoir (19) into the
appliance until the release button (23)
clicks into place.
During use (fig. B2)
• Open the cover (24).
• Fill the water reservoir (19) through the
water filling point (20) with water.
• Close the cover (24).
Setting the temperature
(fig. A, C & D)
The temperature must be set according to the
type of fabric.
Before you proceed, we need you to pay
attention to the following notes:
15