Preparing The Appliance For Use - Nova 320300 Bedienungsanleitung

Some parts of the iron are lightly greased,
and it is possible that the iron will emit a
little smoke when used for the first time.
This smoke will stop after a short period of
time, and is not indicative of a defect.
3 To remove residue from the soleplate,
set the temperature control dial to
'max', and iron over a damp cloth.

Preparing the appliance for use

• It is recommended that you fill the
water reservoir with a mixture of 50%
tap water and 50% distilled water. This
is particularly desirable in areas with
hard water, since this will prevent the
formation of excessive limescale.
• Make sure the water reservoir is
always filled, even if you do not plan
to use the steam function.
1 Place the appliance on a flat sturdy
surface.
2 Make sure the appliance is not plugged
in.
3 Use your thumb to press the reservoir
lock (No.13) downwards, and pull the
reservoir forwards with your fingers.
4 Fill the water reservoir with the
indicated quantity of water (no higher
than the 'max' level).
5 Replace the water reservoir by
positioning the base over the projection
and then clicking the top in place.
Use
• Never iron over zips, rivets in jeans,
etc. These will damage the soleplate.
Iron around any such objects.
• The steam generator's holder for the
iron will become hot. Do not touch it
whilst you are ironing.
• Never point the soleplate at persons
during use, steam is very hot.
• Check whether ironing-instruction
labels are attached to clothing. Always
observe any such instructions.
• The filling aperture of the water
reservoir must not be opened during
use.
• Do not remove the Calc Clean
descaling cap from the body of the
generator at any time. Behind the cap
is a water outlet which connects
directly to the steam generator and it
is very hot during use!
• Make sure that the appliance can not
fall when you place the iron on the
holder.
Dry ironing
1 Fill the water reservoir (No.10).
2 Put the iron on the steam generator's
holder (No.11).
3 Put the plug in the wall socket.
4 Turn on the ON/OFF switch and turn
the iron's temperature-control dial
(No.2) to adjust the temperature to the
required setting. The iron starts heating.
5 Adjust the temperature in accordance
with the directions given in table 1.
6 When the indicator light on the iron
(No.3) turns off, the temperature is
reached. You now can start ironing.
Steam ironing
1 Fill the water reservoir.
2 Put the iron on the steam generator's
holder.
3 Put the plug in the wall socket.
4 Make sure that there is enough water in
the reservoir.
5 Set the on/off switch steam generator
(No.6) to 'I'. The steam generator starts
to pump the water and heat it. The
indicator light "steam ready" illuminates
when steam is ready.
6 Meanwhile adjust the temperature by
turning the iron's temperature-control
dial to the required setting. Adjust the
temperature in accordance with the
directions given in table 1.
Steam Station Star Deluxe Article 320300
9