Preparing The Appliance For Use - Nova 320200 Bedienungsanleitung

1 Before using the iron for the first time,
verify that the mains voltage stated on
the base of the steam generator is the
same as your mains voltage.
2 Remove all labels and stickers that may
be attached to the iron.
Some parts of the iron are lightly greased,
and it is possible that the iron will emit a
little smoke when used for the first time.
This smoke will stop after a short period of
time, and is not indicative of a defect.
3 To remove residue from the soleplate,
set the temperature control dial to
'max', and iron over a damp cloth.

Preparing the appliance for use

• It is recommended that you fill the
water reservoir with a mixture of 50%
tap water and 50% distilled water. This
is particularly desirable in areas with
hard water, since this will prevent the
formation of excessive limescale.
• Make sure the water reservoir is
always filled, even if you do not plan
to use the steam function.
1 Place the appliance on a flat sturdy
surface.
2 Make sure the appliance is not plugged
in.
3 Remove the water reservoir cap (No.4)
from the top of the water reservoir.
4 Fill the water reservoir with the
indicated quantity of water.
5 Put the water reservoir cap (No.4) back
on the water reservoir and close it
tightly.
Use
• Never iron over zips, rivets in jeans,
etc. These will damage the soleplate.
Iron around any such objects.
• The steam generator's holder for the
iron will become hot. Do not touch it
whilst you are ironing.
• Never point the soleplate at persons
during use, steam is very hot.
• Check whether ironing-instruction
labels are attached to clothing. Always
observe any such instructions.
• The filling aperture of the water
reservoir must not be opened during
use.
• Make sure that the appliance can not
fall when you place the iron on the
holder.
Dry ironing
1 Fill the water reservoir.
2 Put the iron on the steam generator's
holder (No.6).
3 Put the plug in the wall socket and set
the on/off switch iron (No.11) to 'I'. The
iron starts heating.
4 Adjust the temperature by turning the
iron's temperature-control dial (No.1) to
the required setting. Adjust the
temperature in accordance with the
directions given in table 1.
5 When the temperature indicator light on
the iron (No.13) turns off, the
temperature is reached. You now can
start ironing.
Steam ironing
1 Fill the water reservoir.
2 Put the iron on the steam generator's
holder (No.6).
3 Put the plug in the wall socket and set
the on/off switch iron (No.11) to 'I'. The
iron starts heating.
4 Set the temperature-control dial (No.1)
in the desired position.
5 Set the steam generator switch (No.9)
to 'I'. The steam generator will now heat
the water. Once the water has reached
the required temperature, the indicator
light "steam ready" on the base's
control panel (No.7) will light.
6 Adjust the temperature by turning the
iron's temperature-control dial (No.1) to
the required setting. Adjust the
Steam Station Star Article 320200
9