Spypoint HD-10 Bedienungsanleitung Seite 5

8
Photo
VIDEO
To take videos. The « VIDEO » mode must be
selected by pressing « OK »; the test light in the
Video
front of the camera will wink for 60 seconds to
allow the operator to walk away from the camera.
T
TEST
To set the camera or the distance. The « TEST »
mode must be selected, no picture or video will
Test
be recorded. Walk perpendicularly in front of the
camera. When the camera detects movement, the light winks
to indicate that normally, a photo or video would have been
recorded. If the system does not detect the movement, increase
the distance detection using the wheel « DISTANCE » or realign
the system differently. Once you understand how the device
responds to detections, you can better adjust the direction or
the height of the camera (Recommanded installation height:
about 3 feet).
In "Test" mode, it is possible to take a picture by pressing
the "OK" button. The photo is saved and appears in "View"
mode.
SETTINGS
Serves to allow own operator settings. To configure
the system in English, hold the button «  » until
Settings
« Language » is highlighted. Press « OK », select
« English » with the button «  » or «  » and confirm your
choice with « OK ». The system will change all the menus in
English by itself.
Allow the user to set the period of operation
Time Start /
of the camera. The start and stop time are the
Time Stop:
hours during the camera is in action and records
pictures or videos. Example: if the user selects
a start time "7:00 am" and a stop time "11:00
am", the camera will only detect for that period
of time and will stay inactive for the remaining
hours. Press "OK" and use "" or "" to adjust
the hour. Press again "OK" to set the minutes.
When the time is properly set, press "OK" once
more to go back to other settings.
9