Maxi-Cosi CabrioFix Gebrauchsanweisung Seite 10

EN
Shell
1
Belt buckle
2
Crotch strap with belt pad
3 a
Shoulder belts with belt pads
3 b
Slots to adjust shoulder belts
4
Support pillow
5
Carrying handle
6
Push button for adjusting carrying handle
7
Belt hook for lap section of safety belt
8
Rear belt hook for shoulder section of safety belt
9
Belt tensioner strap
10
Control button of the quick adjuster
11
Control button for removing car seat from
12
Maxi-Cosi or Quinny frame
Belt hooks
13
Instuctions and airbag warning sticker
14
Rim (for storing sun canopy)
15
Sun canopy (built-in)
16
Instruction manual
17
Storage compartment
18
Mounting bars for FamilyFix and EasyBase 2
19
18
Safety
General CabrioFix instructions
1. You are personally responsible for the safety of your
baby at all times.
2. Never hold your baby on your lap when driving.
3. The CabrioFix is developed for an intensive use of
approximately 10 years.
4. We advise to check the expanded polystyrene (EPS)
parts regularly for damages.
5. Do not use second-hand products whose history is
unknown. Some parts could be broken, torn or missing.
6. Replace the CabrioFix when it has been subject of
violent stresses in an accident: the safety of your child
can no longer be guaranteed.
7 Read this instruction manual carefully and keep it in the
storage compartment in the CabrioFix.
WARNING :
Do not make any changes to the
CabrioFix whatsoever, as this could affect the
performance of the car seat and render it unsafe.
WARNING :
Children have STRANGLED in loose or
partially buckled harness straps. Fully restrain the child
even when carrier is used outside the vehicle.
The CabrioFix and your baby
1. Never leave your baby unattended.
2. Always secure your baby with the harness belt.
3. Before every use, make sure the harness is not
damaged or twisted.
4. Make sure you can fit no more than one finger between
the harness and your baby (1cm).
5. Only use the support pillow of the CabrioFix when the
shoulder belts are in the lowest position.
WARNING :
Never place the CabrioFix on an elevated
surface (such as a table or chair).
CabrioFix car use
1. Always check to make sure the car seat can be installed
properly in your car before purchasing it.
2. Make sure that any fold-down rear seat is locked into
position.
3. Prevent the CabrioFix from becoming trapped or
weighed down by luggage, seats and/or slamming doors.
4. Make sure that all luggage and other loose objects are
secure.
5. The safest place for your baby is the rear of your
vehicle, however if you need to install the seat in the
front passenger seat, please ensure that any airbag is
deactivated.
6. Only use a forward-facing seat that is fitted with a
3-point safety belt that complies with the ECE R16
standard (at a minimum).
7. Make sure the car safety belt buckle runs in a straight
line and stays below the belt hook of the CabrioFix. See
the p.8 example.
EN
8. The car safety belt must be threaded along
all blue markings. For proper installation
instructions, see pages 8-9 and/or the sticker
on the side of the CabrioFix.
9. Always cover the CabrioFix when exposed to direct
sunlight in the car. Otherwise, the cover, metal and
plastic parts could become too hot for your child's skin.
WARNING :
The CabrioFix may only be installed in a
rear-facing position in the car.
CabrioFix maintenance instructions
1. The CabrioFix must undergo regular maintenance.
Do not use lubricants or aggressive cleaning agents.
2. The cover, cushions and belt pads of the
CabrioFix can be removed in order
for these to be cleaned (also see washing instructions).
The flexible plastic edge can be cleaned with water,
soap and a soft cloth.
3. If the cover needs to be replaced at any time, only use
official fabrics.
19