Vicair Adjuster O2 Gebrauchsanweisung Seite 5

• Place cushion by pressing firmly.
• Place the O2 Top Cover over the top of the
cushion.
• Pass the loop at the back of the cushion
through the 'button hole' in the back of the
cover.
• Sit on the cushion for a few minutes, to allow
the cushion to adapt to your body shape.
• If necessary, adjust footrest(s).
Alternative cushion covers
Perform the following steps when using the
Comfair Cover or the Incontinence Cover:
• Check cushion size. Width (X) of the cushion
and seat should match. When the cushion
rests against armrests or side-guards, the
width may be up to 2,5 cm (1") wider. Depth
(Y) of the cushion and seat should match.
• Check if the size of the cover matches the
size of the cushion.
• Remove the Velcro strips from the bottom of
the cushion. Note that the strips confected to
the bottom of the cushion cannot be
removed.
• Insert cushion in cover.
• Pass loop through eyelet in cover.
• Close zipper. Make sure to not damage the
cushion.
• Remove protective backing tape from
selfadhesive Velcro strips attached to the
cushion cover.
• Place cushion by pressing firmly.
• Sit on the cushion for a few minutes, to allow
the cushion to adapt to your body shape.
• If necessary, adjust footrest(s).
Checking for "bottoming out":
Warning! Your tailbone and pelvic bones should
not touch the bottom of the cushion. Checking
for "bottoming out" should be done during first
use and after adjustments to the cushion filling.
Warning! Vicair B.V. recommends to adjust the
filling grade under the direct supervision of your
therapist or technical advisor.
• Check for bottoming out, after sitting on the
cushion for approximately 5 minutes.
• Let your therapist or technical advisor slide a
hand between your buttocks and the Vicair
cushion while leaning forward.
• Ask your therapist or technical advisor to
check if your lowest bony prominences are
supported by at least 2,5 cm / 1" of
SmartCells™. This prevents them from
touching the wheelchair seat.
• Do not use the cushion if bottoming out
occurs. In most cases, adjusting the filling
grade of the compartments will solve the
problem.
USE
Checking for redness of the skin
Warning! Check your skin regularly for redness,
especially during the first few days. If redness
occurs and does not disappear after 15 minutes,
consult your therapist or technical advisor.
Adjusting the filling grade
Warning! Vicair B.V. recommends to adjust the
filling grade under the direct supervision of your
therapist or technical advisor.
Ready for use
This Vicair product is ready for use. It has its own
unique filling grade, depending on size and
model and automatically manages small
obliquities. However – if necessary to support
more extreme asymmetry – the filling grade can
be adjusted by removing or adding SmartCells
from/to the various compartments. You can find
the default filling grade on the label attached to
the cushion.
E N
5