Allgemeiner Teil / General Section
Ausbauhinweise
Gehäuseoberteil
- 3 Schrauben A herausdrehen (Fig. 1).
- Gehäuseoberteil nach hinten abziehen.
C
CH.ADJ.
MAINS
INPUT
230V
50/60 Hz
13W MAX.
A
Frontblende
- Gehäuseoberteil abnehmen.
- 2 Schrauben B an den Seitenteilen herausdrehen (Fig. 2).
- Frontblende nach vorne abnehmen.
Chassisplatte
- Gerät öffnen.
- Frontblende abnehmen.
- 3 Schrauben C an der Rückseite herausdrehen (Fig. 1).
- Befestigungsmutter F für den SAT-Tuner entfernen.
- 2 Abstandshalter D in der Chassisplatte zusammendrücken (Fig. 2),
Druckplatte nach oben ausrasten und Chassisplatte nach vorne
herausziehen.
B
Fig. 2
1 - 4
C
TV /VCR
L
TV
AERIAL
AUDIO
OUT
R
D
Disassembly Instructions
Upper Part of the case
- Undo 3 screws A (Fig. 1).
- Remove the upper part of the case towards the back.
A
DECODER
VCR
DO NOT REMOVE COVERS
HAZARD-LIVE PARTS
Fig. 1
Front Panel
- Remove the upper part of the case.
- Undo 2 screws B one on each side of the case (Fig. 2).
- Remove front panel forwards.
Chassis Board
- Open the receiver.
- Remove the front panel.
- Undo 3 screws C from the rear panel (Fig. 1).
- Remove fastening nut F for the SAT Tuner.
- Release 2 expansion clips D at the main PCB (Fig. 2), lift the main
PCB upwards and forwards.
F
LNC
13V/18V
300mA DC
MADE IN U.K.
A
B
GRUNDIG Service
STR 6100