Quick Start - Megasat Countryman GPS Premium Benutzerhandbuch

2. Operating instruction
D Change satellite
Funktion Description
"Satellite
CCW / CW button" Light
"OK" button
E Back to „Home Position"
Funktion Description
"HOME" button
F GPS LED display
Funktion Description
„GPS" LED
Warning!
When starting the motor, the antenna will automatically moves to the park
position. To ensure this please don't turn off the controller!
ENGLISH
08
Operation
if you want to change desired satellite, you can change the
target satellite using the "CCW / CW" buttons, then press
the "OK" button to select the new satellite.
Operation
Whenever you wish to return the antenna back to the
Home position, press and hold the"Home" button for a few
seconds.
Operation
When your Countryman GPS identifies a GPS signal,
GPS LED light will remain on, regardless if the antenna is
pausing or moving. GPS can help to search for the satellite
faster & catch the optimum satellite signal, and assist
Countryman GPS Premium to acheive the best elevation
& skew angle.
Also, while program updating, the GPS LED light will flash
to show the update procedure is processing. During this
time, GPS LED light on doesn't mean the unit is communi-
cating with GPS satellite.
2. Operating instruction

Quick Start

Description
1. Take out the antenna from carrying case, and place it on the flat ground (or mount it on
the top of the camper) facing South & no obstacle.
2. Connect the left port of the antenna, which located at the rear of the main unit, to the
controller using controller cable.
a) One end of the controller cable connect to „controller" port of the main unit of
Settings the antenna.
& b) The other end of the controller cable connect to the port of the controller.
Connecting 3. Connect the power cable to controller.
a) If you use the power source from a car or caravan etc, use the cigarette lighter
adaptor to connect the power to controller.
b) Otherwise use a suitable 12 Volt DC adaptor to connect the power to controlle.
4. Connect between the right port of the antenna, which located at the rear of the
main unit, to the receiver using receiver cable..
1. Switch on with the "Power switch" button on the top of the controller.
2. Upon power on, all LED will flash twice.
3. Wait until "HOME Status" light & one "Satellite LED" light, which you set previously or the
first satellite in the controller (Turksat), remain solid on.
Operation 4. Select the desired satellite using the "CCW / CW" buttons, then press the "OK" button to
(Search satellites) select.
5. IF the satellite LED light starts flashing, please wait for a while until it turns to keep the LED
on steadily.
6. When the satellite LED light stays on, the selceted satellite has been located and a signal
can be seen on the satellite TV.
When you move the car, the flat dish of the antenna must be at the
Home position.
ENGLISH
09