Operating Instruction Connection Diagram; Functional Description - Megasat Countryman GPS Premium Benutzerhandbuch

2. Operating instruction
Connection Diagram
Controller cable
color black
Use the black color 5C Power cable to connect between the controller and antenna. The controller cable looks
similar to the antenna receiver cable but you can distinguish them by the color and labeling.
ENGLISH
06
Television
Receiver cable
color grey
set-top box
plus pole (+)
car cable
Minus pole (-)
Ignition
2. Operating instruction

Functional Description

A Power On
Function Description Operation
ON OFF
"Power" Switch When the all cable connections are completed,
switch on with the "Power Switch" button on the
top of the controller.
„Home Status" light If the antenna was at home position, "Home status" light
Stand By „ON" will be solid on to show it is ready to use.
„Home Status" If the antenna was not in the home position, "Home status"
light Flashing light will flash, and the antenna will return to the home
position within a maximum 2 minutes. Then will be solid on.
Turning into „ON"
The "Home position" means antenna completely folded down to the body part which is
the basic position for functioning.
B Selecting the satellite
Funktion Description Operation
Once antenna and controller are connected, you can
""Satellite
select & change the satellite as you desire.
CCW / CW button"
Select the preferring satellite using the "CCW / CW"
Light"
buttons, then press the "OK" button to accept the setting.
If you select the wrong satellite, you can re-search target
satellite using the "CCW / CW" button, then press the "OK"
"OK" button
button to accept the new setting.
C Satellit suchen
Funktion Description Operation
After the satellite selection, "Home Status" light will go off
and the LED light of the selected satellite will start flashing.
"Satellite" light
Once selected satellite has been found, the LED light of
the satellite will become solid.
ENGLISH
07