Adjustment Of The Azimuth (Vertical Needle-Position In The Groove) - Clearaudio TT3 Bedienungsanleitung

User manual / Bedienungsanleitung
Pic. 15: Adjustment of the tonearm
The tonearm angle can be adjusted with the screw in the tonearm base (see pic. 16 b). The tonearm
angle is correct adjusted, if the bubble level is centered.
Pic. 16 a: Bubble level
Adjust the correct stylus pressure as instructed in the cartridge´s user manual.
To achieve the exact stylus pressure we recommend the use of the clearaudio digital stylus pressure
gauge "Weight Watcher" (Art.-#: AC 094; also available at www.analogshop.de).

4.3 Adjustment of the azimuth (vertical needle-position in the groove)

a
a = b
Pic. 17: Adjustment of the azimuth
10
The carbon headshell tube should be parallel to the
surface of the record (without needle protection
and cartridge lifted down record!).
To ensure a stable function mode of the tonearm,
please tighten the screws on the side of the tone-
arm (allen wrench wrench # 2; see pic. 15).
Please unlock the screws to change the height of
the tonearm.
Pic. 16 a: Adjustment of the tonearm`s tilt angle
Please be very careful by the following steps:
Lift your cartridge up (!)
Take a straight bar or rod (e.g. hex key wrench) which can
be placed on the top of the cartridge.
Place this piece on top of the headshell as shown in the
b
picture 17 and secure it with a piece of adhesive tape.
© clearaudio electronic GmbH, 2017/11