Initial Operation - Clatronic DG 3547 Bedienungsanleitung, Garantie

Using the rice bowl
1. Put rice or other foods with sauce or liquid in the rice bowl.
2. Place the rice bowl into a steam bowl.
3. Finally, put the lid on.
NOTE:
Please continue observing our "Cooking instructions".
There you will find suggestions on water quantities for
different rice grades.
Functions
The steamer features different functions:
• Select the cooking time and the steamer will start operation
after approx. 5 seconds automatically.
• You may also set the timer for the food to be ready at a
preset time.
• After the steamer has cooked for the set amount of time, it
will enter a keep-warm mode.
• Overheat protection: If the water is used up, the device will
turn off after some time.

Initial operation

• After filling with water, first place the collection tray and then
the steam bowls and the lid.
• Position the lid with the steam opening on the back.
Mains connection
1. Check if the mains voltage that you want to use matches
that of the appliance. You will find the information about this
on the type plate of the basic unit.
2. Check the switch setting of the ON/OFF switch. It must be
disengaged.
3. Connect the device to a properly installed isolated ground
receptacle.
Operating instructions
Instant steam function
1. Turn the appliance on with the ON/OFF switch. You will
hear a signal tone. The display and the pilot lamp will light
up blue.
2. Press SET button once. The display will show the default
setting of 5 minutes "00:05".
3. If you wish to steam cook longer than 5 minutes, set the
cooking time by pressing the minute button MIN repeatedly
or the hour button HR for 1 hour setting.
4. If the set cooking time is longer than 50 minutes, please
refill with water during operation before the 50 minutes
have elapsed. Otherwise the device will turn off.
NOTE:
• The maximum time setting is 1 hour and 59 minutes.
• During this process the readout "STEAMER" (translated:
steamer) will blink on the upper right of the display.
48
NOTE:
• If you wish to change your input, press and hold the
respective button MIN or HR until the desired values are
displayed.
• If no button is pressed within 5 seconds after input, the
device will start heating water automatically. The readout
"STEAMER" will then illuminate steadily. The control
lamp changes from blue to red.
• The timer counts down. When elapsed, 5 signal tones
will alert you that the cooking has been finished.
Delayed cooking
1. Turn the appliance on with the ON/OFF switch. You will
hear a signal tone. The display and the pilot lamp will light
up blue.
2. Press SET button once. The display will show the default
setting of 5 minutes "00:05".
3. Set the cooking time by pressing minute button MIN repeat-
edly or hour button HR for 1 hour setting.
4. Press SET button a second time.
5. Set the time for the device to start cooking, using the MIN
and/or HR buttons.
NOTE:
• During this process the readout "TIMER" (translated:
timer) will flash on the upper right of the display.
• You may delay cooking by maximum 12 hours and
59 minutes.
• If you wish to change your input, press and hold the
respective button MIN or HR until the desired values are
displayed.
• If no button is pressed within 5 seconds after input, the
timer will automatically start to count down. The readout
"TIMER" will then illuminate steadily. When the time of
the TIMER has elapsed, the device will automatically turn
to "STEAMER" mode and start cooking. The control lamp
changes from blue to red.
WARNING:
Never operate the device unattended. When setting the
timer to delay cooking, set a time that ensures operation with
proper supervision.
Keep-warm mode
• After the cooking time has elapsed, a signal tone will sound
5 times.
• The display will show the readout "00:00", and below that
"KEEP WARM".
• The control lamp will change from red to blue. The keep-
warm mode starts.
• The heater will turn on and off in intervals. During heating
the control lamp will light up red.
• The device counts the minutes onwards. The display will
show the elapsed time during keep-warm mode.