Schneider SFD540NF B Bedienungsanleitung Seite 67

1. The appliance is not installed on a
flat and level ground.. The appliance
touches a wall or another object.
2. Frozen food is stored improperly.
3. Items have dropped behind the
appliance.
1. The water pan
bottom of the cabinet) may not be
properly levelled, or the draining
spout (located underneath the top of
the compressor depot) may not be
properly positioned to direct water
into this pan, or the water spout is
blocked.
1. The LED light may be damaged.
2. The control system has disabled the
lights due to the door being kept
open too long.
If the appliance shows a malfunction not noted on the schedule above or if you
have checked all items on the above schedule but the problem still exists, please
contact the aftersales service.
T
HE OPERATING CONDITIONS DESCRIBED BELOW ARE NORMAL
 The refrigerant generates a sound similar to flowing water.
 Sometimes you may hear a sound which is generated by the injection process of
the cooling circuit.
 The sides of the appliance may get warm while the appliance is running.
When you operate the appliance for the first time or the temperature falls below
a certain level, the appliance will operate with high power to reach the preset
temperature.
may be generated inside or outside the appliance by high humidity or very warm
ambient temperatures.
20 depending on model
Uncommon noise.
Water drips on the floor.
20
(located at the rear
The light is not working.
AND DO NOT INDICATE A MALFUNCTION
Condensed water in / on the appliance
1. Install the appliance properly.
2. Store food properly.
3. Remove the items.
1. You may
refrigerator away from the wall to
check the pan and spout.
1. Refer to replace LED lights in
cleaning and care chapter.
2. Close and reopen the door to
reactivate the lights.
Distinct noise
67
need to pull
.
the