Power Supply; Changing The Battery - Kaba Mauer 82021 Code-Combi K Bedienungsanleitung

GB
5

Power supply

The lock is powered by means of a 9-volt block battery. We recommend using an alkaline/
manganese battery with reduced heavy metal content
When changing the battery, please dispose of old batteries in an environmentally friendly
manner using recycling/collecting boxes. Batteries should never be thrown on the fi re, into
water or thrown away with normal household waste.
Insuffi cient power supply
1) After pressing ON
2) Replace battery without delay
Low voltage is shown if the red LED fl ashes 10 times after the ON button is pressed. There
is still suffi cient energy for opening approximately 50 times, but no further programming
sequences should be carried out.
When low voltage is indicated, please change the battery immediately. If the low battery sig-
nal is ignored for a long period the number of possible opening cycles may be reduced due
to the battery's automatic discharge.

5.1 Changing the battery

Press the catch on the top edge of the battery cover with a screwdriver and lever of battery
lid. Pull the battery out carefully until the battery clip is visible. Release the battery from the
clip and replace. Re-engage the lid. Please ensure that the cable is not damaged.
Diagram 2: Battery case
CLAVIS Deutschland GmbH
Schillerstraße 47-51
34117 Kassel
Telefon: +49 (0)561 988 499-0
Fax: +49 (0)561 988 499-99
10 x
E-Mail: info@tresore.eu
Internet: www.tresore.eu
www.tresorschloss.de