GB
4.2.2.2 Opening with dual code by dual code holder
1) Press ON
2) Enter valid 6-digit 1
3) Enter valid 6-digit 2
4) Within 4 seconds turn bar handle clockwise until stop position reached
If the lock was last opened with the primary code, the signal 3 x
The correct sequence of the partial codes must be adhered to. In order to open the lock the
st
1
part of the combination has to be entered followed by the 2
4.2.3 Opening after 3 or more incorrect code entries
After 3 incorrect entries the lock goes into a one minute blocked status. The period in which
the lock is blocked is extended to 2, 4, 8 and a maximum of 16 minutes every time an
incorrect code is entered. During this period the red LED fl ashes every second and it is not
possible to enter any further codes. When the blocked period is over, ON may be pressed
again at any time.
1) Press ON
2) Enter valid code
Signal: Invalid code was entered during former opening attempt
3) Within 4 seconds turn bar handle clockwise until stop position reached
4.2.4 Alteration of primary code by primary code holder
1) Open lock with valid 6-digit primary code (see 4.2.2.1)
2) Press ON
3) Press P
4) Enter valid 6-digit primary code
5) Enter new 6-digit primary code
6) Enter new 6-digit primary code again
Test newly programmed primary code by closing and opening once
7)
more
If the new primary code as per 6) was incorrectly confi rmed, the signal 3 x
Repeat the sequence.
CLAVIS Deutschland GmbH
Schillerstraße 47-51
34117 Kassel
st
part of combination
nd
part of combination
Telefon: +49 (0)561 988 499-0
Fax:
+49 (0)561 988 499-99
1 x
1 x
appears.
nd
part of the combination.
penalty time
1 x
3 x
1 x
appears.
E-Mail:
info@tresore.eu
Internet: www.tresore.eu
www.tresorschloss.de
/ 2 x