External Power Supply; Merger Representation; Cleaning And Care; Repair And Spare Parts Service - Andres Industries TILO-3M Handbuch

External power supply

The external power supply is connected to the TILO
with a cable and a waterproof plug. When using 3
AA batteries, the running time can be increased to a
total of 8h. When the external power supply is used the
AA batteries are first used up. Afterwards the CR123
is used. With the external power supply, the TILO
Merger representation (Augmented Reali
The TILO - 3™ can also be used as thermal goggles
when both eyes are open. Then, the image fusion
of thermal image (left) and real image (right) occurs
in the brain. Instead of a real image, the second
eye could also be equipped with a residual light
amplifier.

Cleaning and care

Clean the TILO with clear water, if necessary with a
cleaning agent and a brush or cloth.

Repair and spare parts service

We have built the TILO - 3™ as small and as light as
possible. Though, it is very stable and it is hardly
possible to damage it in daily use. Should any
damage occur or components be lost, we will be
happy to supply spare parts.

Order numbers of spare parts

Flap: No.380207
Battery closure including strap and screw:
No.380208
40
can also be operated with AA batteries only. It is also
possible to use rechargeable batteries.
The external power supply is attached with Velcro to the
back of the helmet or to the headband.
Alternatively, a powercable with USB-plug for use
with a powerbank is available.
ty)
(This is only possible in zoom mode 1 ).
×
Depending on the user, double images may occur
despite the factory calibration performed in advance.
In this case, a collimation should be performed.
Do not use strong chemical detergents.

Repair

If there is a defect in the device, please write us an
e-mail with the purchase date and the invoice copy
before sending it to us for repair.
info@andres-industries.de
You will then receive an RMA number. If the repair
takes place within the warranty period, we cannot
guarantee that you will get back your device. In
general, you will receive an updated version with the
latest software.
Update-Service
Our products are constantly being further de-
veloped. TILO is also continuously developing
further. To ensure that your TILO is always up-to-
date, we also offer a fee-based update service. You

Troubleshooting

Problem Cause
Batteries empty or incorrectly instal-
led?
Screen too dark?
Device can't be
turned on /
Flap defective or turn off?
Device doesn't shut off
Device may be located in the
Video mode PAL or NTSC?
– Device is in manual calibration
mode?
– Device has been running very long or
Bad image quality
is warming up otherwise?
– Calibration has been interrupted.
– Battery almost empty?
Device doesn´t start
Software crash
despite battery inserted?
Screen bright, but no Shutter is locked. Occurs with weak
image visible batteries.
can then send your TILO to us and we update both
hardware and software. Finally, the device is still
tested for water tightness and is filled with a fresh
nitrogen filling, then you get it back updated. Please
visit our website for more information.
Solution
Check battery position or replace
battery.
Push button 1 several times.
The device can also be operated
without a flap, see Quick Start Guide
(Button 1 and 2).
Press button 1 for 5 seconds.
(more p. 36)
Carry out manual calibration, close
the flap for approx. 0.5s, but do
not lock.
Insert new battery.
Remove the battery for 30 s and
reinstall.
Switch off the device and switch it
on again. Insert new battery.
41