Use On A Stroller - KIDDY Evoluna i-Size 2 Bedienungsanleitung

EN
restraint system. If the shock absorbers prevent the installation of the
child restraint system in the vehicle, due to the width of the vehicle,
these can be removed.
To do this, rotate the shock absorber (fig. 22) until it is released from
the lock and then pull it off the carrying handle sidewards (fig. 23). For
assembly, carry out the steps in reverse order. Please note that the
direction of rotation of both shock absorbers is different.
Should the shock absorbers impair the fitting of the child restraint
system on a stroller, these can also be removed.
WARNING
The shock absorbers are an essential part of the
safety concept of the child restraint system and
should only be removed if it is not possible to in-
stall the child restraint system properly for reasons
of space. Do not forget to refit the shock absorbers
during a possible vehicle change.

8. Use on a stroller

Ensure that the respective adapters are properly and in correct direc-
tion mounted to the stroller.
Now place the infant carrier on the adapters with the head-end in the
direction of travel (fig. 24, no. 1). Check that everything is locked into
place.
Now you can decide whether you want to adjust the child restraint
system in a seated or reclined position (see point 5.1).
To release the Evoluna i-Size 2 from the stroller, press both release
buttons down (fig. 25, A) and, at the same time, lift the infant carrier
from the stroller (fig. 25, B).
15