Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. Run the vacuum hose. Observe the maximum delivery height
(Technical Data).
Operation
1. Insert the power plug into a protected socket. Pumping will start
automatically as soon as the pump is plugged in.
Make sure that no particles bigger than approx. 2 mm get sucked as
this can block the pump.
Do not operate the pump unsupervised during operation!
2. Pull the power plug to turn off the pump.
Thermal Circuit Breaker – Overheat Protection
The pump is equipped with an automatic thermal protection, which
prevents damage to the pump caused by overheating. If the pump
becomes too hot during operating, it will automatically switch off. Pull the
plug of the pump and allow the pump to cool down for approx. 30 minutes
before operating again.
Running Dry
Absolutely avoid dry running of the pump! Dry running is operating the
pump without water in the casing.
Maintenance, Cleaning, Storing and Transport
Unplug the power plug before undertaking any kind of maintenance
work or before cleaning.
The pump does not require maintenance apart from occasionally
cleaning the housing.
When opening covers or removing casing parts you may expose live
parts. Capacitors inside the device may still carry voltage even though
they have been disconnected from all voltage sources.
Never use corrosive or acidic cleaners to clean the pump.
Keep the suction base (5) free from dirt and blockages of any kind to
prevent clogging.
Store the pump in a dry place that is protected from dust, dirt and frost.
Operation
14
Werbung
Inhaltsverzeichnis
