Oase Lunaqua 2002 Gebrauchsanweisung Seite 10

Replacing bulb
1. Disconnect light and safety transformer from mains and make sure that they
2. Remove pond light from water and dry it.
3. Unscrew cover (7) in an anti-clockwise direction. Caution! Do not touch the
4. Remove bulb from holder and replace it.
10
7
5. The wattage on the bulb must correspond to the wattage indicated on the type
8
9
6. Check that the O-ring (8, Detail X) and the reflector plate (10) are sitting correctly
7. Screw the cover (7) back onto the lamp casing in a clockwise direction,
8. You can now install the pond light again and start it up (see "Start-up").
X
Cleaning
1. Disconnect light and safety transformer from mains and make sure that they
2. Remove pond light from water.
3. Clean pond light with warm water without any added detergents and with a soft
Storage / Winter storage
When frost is expected, you must remove the pond light! Clean the light thoroughly
(see "Cleaning"). Check the pond light for damage. Store the pond light in a dry and
frost-free place and out of the reach of children.
Advice on disposal
Dispose of your light in an environmentally friendly way. Contact your local refuse
department for advice on disposal.
Repair / Cable replacement
For repair / cable replacement, please send the faulty safety transformer or faulty
pond light directly to the supplier / manufacturer.
Available spares are listed under 'Device overview'.
10
Lunaqua 2002 Exp.p65
GB Operating instructions
cannot be switched on unintentionally.
new bulb (9) directly with your hand as this will shorten the life of the bulb
considerably. Please use a piece of paper or a soft cloth when replacing the
bulb.
label.
and replace if damaged.
ensuring that it is on tight.
cannot be switched on unintentionally.
brush or cloth. Be careful that no moisture gets into the lamp casing.
10
GB
28.03.2003, 11:02