Getting Started; Operation - Hama 00092629 Bedienungsanleitung

• Do not use the product in areas where the use of electronic devices is not permitted.
• Do not place the product near interference fields, metal frames, computers, TVs, etc. Electronic devices and
window frames can negatively affect the product's functionality.
• Do not drop the product and do not expose it to any major shocks.
• Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
• Do not modify the product in any way. Doing so voids the warranty.
• Keep the packaging material out of the reach of children due to the risk of suffocation.
• Dispose of packaging material immediately according to locally applicable regulations.
Warning – Batteries
• Immediately remove and dispose of dead batteries from the product.
• Only use batteries (or rechargeable batteries) that match the specified type.
• When inserting batteries, note the correct polarity (+ and - markings) and insert
the batteries accordingly. Failure to do so could result in the batteries leaking or
exploding.
• Do not overcharge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable batteries and keep them away from uncoated metal
objects.

4. Getting Started

Open the battery compartment, remove the contact breaker and then close the battery compartment.

5. Operation

5.1 Automatic time setting using the DCF signal
After the contact breaker is removed, the display is switched on and an acoustic signal sounds for 2 seconds.
The clock automatically searches for the radio signal. This process can take 3 to 5 minutes. When the wireless
signal is received, the date and time are automatically set and the radio icon
automatically receives the time code every hour. If the clock is unable to receive a time signal wirelessly, the
time/temperature are displayed and the radio icon
5.2 Manually setting the time
Press MODE (4) for 3 seconds in the time/temperature display to set the system date and time. The
disappears. However, if you are within the range of the radio signal, the clock will automatically try to receive
the radio signal.
• Press MODE (4):
the hour digits are blink and can be set by pressing + or – (3) key.
is not visible. In this case, you can set the time manually.
is displayed. The clock
icon
3