DEFA Termini II 1400 Bedienungs- Und Montageanleitung Seite 4

User- & Installation Manual
Detach the bracket from the interior heater. Use a small flathead screwdriver to carefully
release the snap lock and at the same time push the bracket backwards as shown on
the illustration.
Mount the Interior Heater so that all spacing requirements are fulfilled. Use the drill
template as a guide as to where to locate the bracket for the interior heater.
Termini™ is designed for fast installation in the vehicle interior. It can be installed on the
center console , or directly under the glove compartment .
NB! Do not point the blower opening downwards and do not install the interior heater
on the floor or directed towards the seat if effective heating is to be achieved .
Select the most suitable position for the bracket holes and mount the bracket using
the three enclosed screws. It's an advantage to keep the maximum possible distance
between the three screws . The mounting bracket is designed for attachment to uneven
surfaces. Distance bushings can be found in the center of the bracket and can be
'pushed out' and used to build up the drill holes if required .
NB! Take care to ensure that any drill bits and screws used do not damage any cables or
other electrical equipment on the back side of the interior heater where it is installed.
To attach the interior heater, slide it into the mounted bracket as shown in . To remove
the heater from the bracket when mounted, lift up the front (1) and pull forwards
(2).
2 English