Adjust Volume - oneConcept 10021807 Gebrauchsanleitung

Shut off alarm
When alarm goes off, press the STANDBY BUTTON to turn off alarm, the alarm will reset
for next day.
How to turn off the alarm
To cancel the alarm mode: In "STANDBY OFF" mode, press AL.SET button to turn off the
alarm function (until alarm sign „

Adjust volume

• Press VOL.+ button to increase the volume during "STANDBY ON" mode.
• Press VOL. – button to decrease the volume. "STANDBY OFF"
Radio operation
1. Drücken Sie die Standby-Taste, um in den Betriebs-Modus zu wechseln.
2. Drücken Sie die Funktions-Taste, um in den Radio-Modus zu wechseln.
3. How to use the buttons for radio - Manual Tuning: Touch the SKIP+ / SKIP- button to
search for desired frequency. Higher frequency can be selected by touching the SKIP+
button while Lower frequency can be selected by touching SKIP- button - Automatic
Tuning: Touch & hold the SKIP+ / SKIP- button until the display frequency starts run OR
long press the SKIP button to activate Automatic Tuning OR when a station of sufficient
strength has been found Tuning will stop or you can stop the automatic tuning by pres-
sing SKIP+ / SKIP- button.
4. To turn off the radio, Press the STANDBY button.
Preset Tuning
Select your desired station according to the normal tuning procedure.
Press the MEMORY button on the remote, "P-01" will appear and flash on the display, Then
use M+ or M- button on the remote, or touch the PRESET button on the unit to change the
number where the station will be stored. (P01 to P20).
Store the current frequency by pressing MEMORY button on the remote again when you
get the desired number. Repeat the same procedure to set other desired frequencies into
Memory No.1 to No.20. NOTE: The unit can be preset up to 20 stations.
Memory recall
Recall the stored frequencies by pressing M+ or M- BUTTON on the remote, or touch the
PRESET button on the unit to select 1 to 20 stations as desired. NOTE: As stored frequen-
cies can only be stored for long time with the power supplying. The station you stored will
be lost and can not be recalled in case that you cut off the power.
14
" disappears on the LCD Display).