Detax Molloplast B Gebrauchsanleitung Seite 14

Polymerisation of Molloplast ® B
by microwaving
Curing of Molloplast ® B is recommended
in a commercially available microwave flask at 850
watts for 10 min., using microwave suitable dental
plaster for investing. Investing and polymerisation
must be carried out within 8 hours. Ovens without
rotating plate may require a gradual, all-side poly-
merisation by turning the flask.
De-flask after self-cooling to room temperature.
Trimming of the denture
Use normal procedure for trimming the acrylic.
The relined denture base and the functional bor-
ders can be trimmed with Molloplast ® special cut-
ters or grinding sleeves (15 - 20 thousand r.p.m.),
without problems and heat build-up. Use
Molloplast ® pre-polishing discs for smoothing of
rough spots (Fig. 6).
Polishing
Use standard methods for pre-polishing with
pumice, brush or buff, applying commercially
available materials. Mechanical polishing of
Molloplast ® B relined dentures is not possible
– for high gloss polishing Lustrol gloss varnish
is recommended, mixing ratio: 1:1. Prior to the
application of Lustrol gloss varnish base and
functional borders of the relined denture have
to be absolutely clean and dry. Apply Lustrol
with a brush in a thin layer and let it dry for
approx. 10–15 min. resulting in a high lustre
polish (Fig. 7).
Primo adhesive
Primo adhesive ensures optimum bonding of
Molloplast ® B to the acrylic denture base.
However, the adhesive is only applied onto
already polymerised denture base material.
Prior to the application of Primo adhesive
the denture base is prepared according to
Molloplast ® B instructions for use. Then
Primo adhesive is applied uniformly with a
brush 1–2 times onto the clean and dried
denture base. Please note: Primo coating
must cover the entire surface of denture acrylic
in contact with Molloplast ® B. After drying for
approx. 60 - 90 min. Molloplast ® B is pressed
onto the denture and polymerised according to
instructions.