Detax Molloplast B Gebrauchsanleitung Seite 12

Packing of Molloplast ® B
Remove flask from the clamp, open and remove
spacer and PE-foil.
Important:
The acrylic must show adequate stiffness to avoid
deformation by the Molloplast ® B material during
pressing (Fig. 5).
Molloplast ® B needs no mixing. Take Molloplast
with a clean spatula from the jar and pack it on the
pre-pressed acrylic in the flask. Place a new PE-foil
between Molloplast ® B and counter of the flask.
Close flask and pre-press in intervals at 100 kp.
Open flask and remove PE-foil and excess
Molloplast ® B material. Close flask again and press
for approx. 10 - 15 min. at 100 kp. For polymerisa-
tion place flask in the clamp.
Polymerisation
Place flask in cold water and heat up slowly to 100
°C/212 °F.
Polymerisation in boiling water at
® B 100 °C/212 °F for approx. 2 hours.
Cool down flask slowly. Do not "shocktreat" by rin-
sing cold water over the flask!
Polymerisation of Molloplast ® B
by microwaving
Curing of Molloplast ® B is recommended
in a commercially available microwave flask at 850
watts for 10 min., using microwave suitable dental
plaster for investing. Investing and polymerisation
must be carried out within 8 hours. Ovens without
rotating plate may require a gradual, all-side poly-
merisation by turning the flask.
De-flask after self-cooling to room temperature.
Trimming of the denture
Use normal procedure for trimming the acrylic.
The relined denture base and the functional bor-
ders can be trimmed with Molloplast ® special cut-
ters or grinding sleeves (15 - 20 thousand r.p.m.),
without problems and heat build-up. Use
Molloplast ® pre-polishing discs for smoothing of
rough spots (Fig. 6).
Polishing
Use standard methods for pre-polishing with
pumice, brush or buff, applying commercially avai-
lable materials. Mechanical polishing of Molloplast
B relined dentures is not possible – for high gloss
polishing Lustrol gloss varnish is recommended,
mixing ratio: 1:1. Prior to the application of Lustrol
gloss varnish base and functional borders of the
relined denture have to be absolutely clean and
dry. Apply Lustrol with a brush in a thin layer and
let it dry for approx. 10–15 min. – resulting in a
high lustre polish (Fig. 7).
The dentist can now insert the soft-lined denture
into the patient's mouth.
®