E) Delete Taught-In Receiver - Renkforce RS2W Betriebsanleitung

• Start the registration process on the temperature controller.
• Push the button "FUNC" briefly repeatedly until "CANCEL" appears at the
left of the display.
Then keep the button "+/ON" pushed for 2 seconds until the two arrows in
the icon "
The temperature controller is now ready for registration of the receiver
(radio switching socket).
• Keep the operating button on the receiver (radio switching socket) pushed
(approx. 3 seconds) until the two arrows in the symbol "
temperature controller stop flashing.
• The receiver (radio switching socket) switches on to display the end of
registration. The red LED in the operating button of the receiver lights up.
Only a single receiver can be taught to the temperature controller (a
receiver of the RS2W radio switching system, but no dimmer).
When you start a new teaching process and teach in another re-
ceiver of the RS2W radio switching system, the previously taught-in
receiver will be deleted/overwritten.

e) Delete taught-in receiver

If the receiver taught in at the temperature controller is to be deleted, pro-
ceed as follows:
• Start the registration process on the temperature controller.
• Push the button "FUNC" briefly repeatedly until "CANCEL" appears at the
left of the display.
Then keep the button "+/ON" pushed for 2 seconds until the two arrows in
the icon "
• Keep the button "+/ON" pushed for 2 seconds again to delete the taught-in
receiver; the right half of the symbol "
pear.
" flash alternatingly. Then release the button.
" flash alternatingly. Then release the button.
" and the two arrows disap-
" on the
41