D) Teaching In The Receiver For The Temperature Controller - Renkforce RS2W Betriebsanleitung

• Briefly push the button "FUNC" to confirm; the hours of the time flash.
• Set the hours of the time with the buttons "+/ON" and "-/OFF". Keep the
respective button pressed for quick adjustment.
• Briefly push the button "FUNC" to confirm; the minutes of the time flash.
• Set the minutes of the time with the buttons "+/ON" and "-/OFF". Keep the
respective button pressed for quick adjustment.
• Briefly push the button "FUNC" to leave setting mode.

d) Teaching in the receiver for the temperature controller

The receiver has the same build as the radio switching socket of the
RS2W systems, Conrad item no. 1270199). It can be taught to every
radio transmitter of the RS2W radio system.
Before teaching in, observe the operating instructions for the radio
transmitter used.
While teaching, maintain a minimum distance of 20 - 30 cm between
the transmitter and the receiver. Otherwise, registration may fail.
• When the receiver (radio switching socket) is on (LED in the operating but-
ton lit, connected consumer is activated), switch off the receiver first.
For this, briefly push the operating button; the LED in the operating button
must go out.
The receiver (radio switching socket) must be off (LED in the operat-
ing button is off); otherwise, registration cannot be performed.
40