Lake People DAC C462 Bedienungsanleitung Seite 13

THE PROGRAMMING
Pushing the "MODE" button longer than 2
seconds will select the program mode.
This is indicated by the flashing red –6dB LED.
The –36dB Led will now display the status of
the digital output.
-36 dB LED not illuminated = the digital output
carries the original digital signal without gain.
-36 dB LED illuminated = the digital output
carries the digital signal with gain.
A further push on the "MODE" will show the
status which now may be edited.
1/8 on : 7/8 off = the function is deactivated
7/8 on : 1/8 off = the function is activated
The above status may be changed with a push
on the "PHANTOM" button.
Pushing the "MODE" switch again for longer
than 2 seconds will end the program mode.
All adjustments are stored permanent.
13