Initial Operation - m-e CR-D300 Betriebsanleitung

EN

INITIAL OPERATION

Configuring the wireless
socket outlet switch to match
a wireless transmitter
a.) Plug the wireless socket outlet switch into
a regular 230 VAC / 50 Hz mains outlet.
LED (1) will immediately start to flash.
b.) Before LED (1) stops flashing, press the
"ON" button of the desired switch channel
on the wireless transmitter for which the
dimmable wireless outlet is being
configured. The red LED (1) flashes. This
indicates that the process of configuration
has been successfully completed.
Configuring a wireless socket
outlet switch to match several
wireless transmitters
Up to 8 wireless transmitters can be
configured on this dimmable wireless outlet.
14
a.) Plug the dimmable wireless outlet into a
standard 230 VAC / 50 Hz mains outlet and
press button (2) until LED (1) flashes red.
b.) Before LED (1) stops flashing, press for
3 seconds the "OFF" button of the switch
channel set to be deleted on the wireless
transmitter for which the dimmable wireless
outlet was configured. LED (1) will stop
flashing, indicating that the delete process
has been successfully completed.
c.) Repeat these steps for other
wireless transmitters.
Delete already configured
wireless transmitters on the
dimmable wireless outlet
Already configured channels can also
be deleted.