Operation - m-e CR-R1 Betriebsanleitung

EN
the transmitter; the LED (1) goes out again
and the mains voltage at the front socket
(3), and therefore the connected load, is
switched off.

OPERATION

a.) Connect a load to the front socket (3).
b.) For reliable, maximum performance of the
load, refer to the "Technical data" section.
c.) Pressing the corresponding "ON" or "OFF"
button for the switch channel on the
wireless transmitter enables the "Repeater"
wireless socket (the LED (1) lights up) or
disables the "Repeater" wireless socket
(the LED (1) goes out).
d.) The "Repeater" wireless socket can also be
switched on/off manually using the "ON/
OFF" button (2) on the front.
14
Repeater function
The repeater function is activated
automatically and cannot be disabled.
The wireless socket is used for signal
amplification, thereby allowing the
maximum range of the Cuveo network
to be increased so as to ensure reception
over several floors and rooms. The repeater
receives the signals from the Cuveo wireless
transmitter, reconditions them, and forwards
them to the receivers.
MAINTENANCE AND
CLEANING
Servicing or repair works can only be
performed by a qualified person or at
a special service centre. There are no
components in the product that need
to be serviced. At no point must it be
opened or disassembled given the
danger of electric shock.