m-e CR-D300 Betriebsanleitung Seite 15

a.) Plug the dimmable wireless outlet into a
standard 230 VAC / 50 Hz mains outlet and
press button (2) until LED (1) flashes red.
b.) Before LED (1) stops flashing, press for
3 seconds the "OFF" button of the switch
channel set to be deleted on the wireless
transmitter for which the dimmable wireless
outlet was configured. LED (1) will stop
flashing, indicating that the delete process
has been successfully completed.
c.) Repeat these steps for other
wireless transmitters.
Deleting all pre-configured
channels
a.) Plug the wireless outlet into a standard
230 VAC / 50 Hz mains outlet and press
button (2) until LED (1) flashes red.
b.) Before LED (1) stops flashing, again press
button (2). LED (1) will stop flashing,
indicating that the delete process has been
successfully completed.
Delete all configured wireless
transmitters of the dimmable
wireless outlet
All pre-configured channels can be
deleted again.
a.) Plug the dimmable wireless outlet into a
standard 230 VAC/50 Hz mains outlet and
press button (2) until LED (1) flashes red.
b.) Before LED (1) stops flashing, again press
button (2) on the dimmable wireless outlet.
LED (1) will stop flashing, indicating that
the delete process has been successfully
completed.
EN
15