oneConcept Launburg Bedienungsanleitung Seite 17

Sensor Operation Verification
Verify the humidity sensors match closely with the console and the sensors are in the same
location (about 1-3 meters apart). The sensors should agree within 10% (the accuracy is ±
5%). Allow about 30 minutes for all sensors to stabilize.
The humidity can be adjusted or calibrated later to match each other a known source.
Verify the temperature sensors match closely with the console and sensor array in the same
location (about 1-3 meters apart). The sensors should be within 2°C (the accuracy is ± 1°C).
Allow about 30 minutes for all sensors to stabilize.
The temperature can be adjusted or calibrated later to match each other or a known source
Remote Sensor Installation
If you mount one or more of the sensors outside, it is recommended you mount the sensor(s)
on a north facing wall, in a shaded area.
Direct sunlight and radiant heat sources will result in inaccurate temperature readings. Alt-
hough the sensors are water resistant, it is best to mount in a well protected area, such as
under an eve.
Use a screw or nail (not included) to fix the remote sensor to the wall, as shown above.
17