Bosch GCO 2000 Professional Originalbetriebsanleitung Seite 20

OBJ_BUCH-1063-001.book Page 20 Thursday, December 10, 2009 1:03 PM
20 | English
g) If devices are provided for the connec-
tion of dust extraction and collection fa-
cilities, ensure these are connected and
properly used. Use of dust collection can
reduce dust-related hazards.
4) Power tool use and care
a) Do not force the power tool. Use the cor-
rect power tool for your application. The
correct power tool will do the job better
and safer at the rate for which it was de-
signed.
b) Do not use the power tool if the switch
does not turn it on and off. Any power
tool that cannot be controlled with the
switch is dangerous and must be re-
paired.
c) Disconnect the plug from the power
source and/or the battery pack from the
power tool before making any adjust-
ments, changing accessories, or storing
power tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentally.
d) Store idle power tools out of the reach of
children and do not allow persons unfa-
miliar with the power tool or these in-
structions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for mis-
alignment or binding of moving parts,
breakage of parts and any other condi-
tion that may affect the power tool's op-
eration. If damaged, have the power tool
repaired before use. Many accidents are
caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Prop-
erly maintained cutting tools with sharp
cutting edges are less likely to bind and
are easier to control.
g) Use the power tool, accessories and tool
bits etc. in accordance with these in-
structions, taking into account the work-
ing conditions and the work to be per-
formed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
1 609 929 U62 | (12/10/09)
5) Service
a) Have your power tool serviced by a qual-
ified repair person using only identical
replacement parts. This will ensure that
the safety of the power tool is maintained.
Safety Warnings for Cut-off Grinder
Never stand on the power tool. Serious inju-
ries could occur when the power tool tips
over or when accidentally coming into con-
tact with the cutting disc.
Make sure that the guard operates properly
and that it can move freely. Never lock the
guard in place when opened.
Use the power tool only for dry cutting. Wa-
ter penetrating into a power tool increases
the risk of an electric shock.
Keep the mains cable away from rotating
application tools. The mains cable can be
cut through or get caught.
Hold power tool by insulated gripping sur-
faces, when performing an operation where
the cutting accessory may contact hidden
wiring or its own cord. Cutting accessory
contacting a "live" wire may make exposed
metal parts of the power tool "live" and
could give the operator an electric shock.
Keep the handle dry, clean and free from oil
and grease.
Keep hands away from the cutting area
while the machine is running. Danger of in-
jury when coming into contact with the cut-
ting disc.
Do not stand in a line with the cutting disc
in front of the machine. Always stand aside
of the cutting disc. This measure provides
for better protection of your body against
possible splinters in case of cutting disc
breakage.
Never remove cutting remainders, metal
chips, etc. from the cutting area while the
machine is running. Always guide the tool
arm back to the neutral position first and
then switch the machine off.
Bosch Power Tools