Wind Sensor Maintenance; General Comment On Awning Covers - Stobag TERRADO Bedienungsanleitung

Operating instructions
3.2

Wind sensor maintenance

3.3 Cleaning awning covers
to repeat the process. Only wind the awning in when it is completely dry.
For heavier dirt, we recommend a specially developed cover cleaner, used in accordance
with its instructions. A pressure cleaning machine should never be used.
To re-impregnate the acrylic covers, it can be treated with a special impregnation spray,
such as Fabric Guard™.
3.4

General comment on awning covers

Acrylic fibre awning covers are high-performance products with high light and colour
resistance and mould-inhibiting, water and dirt-resistant finish. They will provide many
years of safe, comfortable protection from the sun.
Despite the high level of technology applied in the manufacture of awning covers,
however, the treatment of the cover produces effects that cannot be avoided. These small
cosmetic defects do not affect the life or the functioning of the awning cover. These una-
voidable effects are explained in the consumer information that follows:
All rights to make modifications are reserved
If there is a control system, the mechanical wind sensor
should be checked periodically for damage from external
causes and that it is functioning. Check that it turns in the
wind. If it does not turn correctly, it must be checked by a
STOBAG specialist supplier.
The acrylic covers is impregnated. If it becomes necessary,
clean it as follows:
Small spots can be rubbed off with a clear rubber eraser or
brushed off when dry.
If slightly dirty, the covers can be washed with diluted soap
solution (5%, approx 30 °C) and a soft brush. It should then
be rinsed thoroughly with clear water. It may be necessary
EN-31