Mitsubishi Electric MSC-GE25VB Bedienungsanleitung Seite 8

● OPERATING INSTRUCTIONS ●
C
LEANING
Instructions:
• Switch off the power supply or turn off the breaker before cleaning.
• Be careful not to touch the metal parts with your hands.
• Do not use benzine, thinner, polishing powder, or insecticide.
Front panel
Hinge
1. Lift the front panel until a "click" is heard.
2. Hold the hinges and pull to remove as shown in the above illustration.
• Wipe with a soft dry cloth or wash it with water.
• Do not soak it in water for more than two hours.
• Dry it well in shade before installing it.
3. Install the panel by following the removal procedure
in reverse. Close the front panel securely and press
the positions indicated by the arrows.
Note:
The front panel may come off if it is lifted up past its level position.
En-7
Hole
• Use only diluted mild detergents.
• Do not expose parts to direct sunlight, heat, or fl ames to dry.
• Do not use water hotter than 50°C.
Air cleaning fi lter (Option)
• If the air cleaning fi lter is clogged, it may lower the unit's
capacity or cause condensation at the air outlet.
• The air cleaning fi lter is disposable.
• If the color of the fi lter turns to dark brown, replace the fi lter at once.
• Replace it with a new air cleaning fi lter every 4 months for best
performance.
• Parts Number MAC-1300FT
Air fi lter (Catechin air fi lter)
• Clean every 2 weeks
• Remove dirt by a vacuum cleaner, or wash with water.
• Dry it well in shade before installing it.
What is "Catechin air fi lter" ?
Catechin is a biofl avonoid that is found in green tea that has both antivi-
ral and antioxidant qualities. In addition to these benefi ts, Catechin also
offers excellent deodorizing characteristics. Catechin air fi lter uses this
compound to not only improve air quality but also prevent the spread of
bacteria and viruses in the room.
Note:
• Clean the fi lters regularly for best performance and to reduce power
consumption.
• Moisture in the air conditioner for a long time contributes to growth
of fungi, such as mold. To prevent fungi growth, set to the highest
temperature in manual COOL mode, and operate for 3 to 4 hours to
dry out the inside of the unit.