Safe Handling: Blade; Adjusting The Plate Pressure; Sharpening The Cutting Plate; Removing The Blade - Aesculap Suhl FavoritaCL Gebrauchsanweisung

Aesculap Suhl GmbH
Battery-powered clipping machine Favorita

4.4 Safe handling: Blade

4.4.1 Adjusting the plate pressure

Note
The plate pressure can be adjusted to increase the
cutting power as required (see foldout page)!
Tighten knurled screw 15 so that upper cutting
plate 19 can be moved by hand, by applying
moderate, lateral pressure.

4.4.2 Sharpening the cutting plate

Note
For sharpening the cutting plate, please contact
Technical Service, see Chapter Technical Service.

4.4.3 Removing the blade

Risk of injury caused by sharp
cutting plates!
Apply proper care when handling
WARNING the blade of battery-powered
clipping
Libra.
Loosen knurled screw 15 with leaf spring 16.
Push upper cutting plate 19 under pressure
piece 14 out of the blade.
This completes the disassembly of the blade.

4.4.4 Lubricating the blade

Disassemble the blade, see Chapter Removing the
blade.
Clean upper cutting plate 19 and lower cutting
plate 18 with a soft wipe or brush. Make certain
the gaps in serration 17 are cleaned properly.
Slightly lubricate upper cutting plate 19 and lower
cutting plate 18 with special lubricant for blades
GT604.
8
machine Favorita /
CL
/Libra
CL

4.4.5 Changing the Li-ion battery

9
Fig. 1
Hold battery-powered
Favorita /Libra 3 and press battery release lock 4.
CL
Pull out Li-ion battery 9 from battery-powered
clipping machine Favorita
Insert the charged Li-ion battery 9 in battery-
powered clipping machine Favorita
as it will go.
The battery-powered clipping machine Favorita
Libra 3 is ready for operation.
3
4
clipping machine
/Libra 3.
CL
/Libra 3 as far
CL
/
CL