Charging Principle; Charging Time; Preparation And Setup; Gt203/Li-Ion Battery Gt201 - Aesculap Suhl FavoritaCL Gebrauchsanweisung

2.6 Operating principle of charger

GT203/Li-ion battery GT201

The charger GT203 is designed for the mains voltage/
frequency range 100 V to 240 V / 50 Hz to 60 Hz.
To make the charger GT203 ready for operation,
connect it to mains power by plugging in the mains
plug.
The charger GT203 is equipped with to charging bays.
The first charging bay is for charging the battery-
powered clipping machine Favorita
the second charging bay the Li-ion battery is charged.
Each charging bay has an indicator field on the charger
front panel assigned to it.
Charging starts automatically, as soon as a Li-ion
battery is inserted in the charging station.
The charging time in the charging bays depends on the
charge state and capacity of the Li-ion batteries.

2.6.1 Charging principle

The Li-ion batteries are charged by constant current
pulses.
The charge state of the Li-ion battery is monitored
during charging. Monitoring of the charging curve
ensures that the battery is fully charged without
overcharging.
Additionally, the battery temperature and charging
time are monitored as well.
The charger monitors the battery status and indicates
the charge state via two LED indicators.
LED indicators:
• green = Battery fully charged
• red = Battery completely discharged

2.6.2 Charging time

Charging is stopped as soon as the maximum charging
time is reached.
The charging time is approx. 50 min.
3.
Non-compliance with these rules will result in
complete exclusion of liability on the part of Aesculap.
When setting up and operating the product, always
observe:
– national
– national regulations on fire and explosion
/Libra, while in
– operating advisories according to IEC-/VDE
CL
DANGER
CAUTION

Preparation and setup

regulations
operation,
protection.
regulations.
Fire and explosion hazard!
Do not operate the product in
explosion-hazard areas.
Malfunction of, or damage to the
product caused by improper setup!
Do not expose the product to
direct sunlight or moisture.
Do not cover the ventilation
slots of the product.
Connect the product to the
specified voltage of 100 V to
240 V/50 Hz to 60 Hz.
Ensure that the mains power
socket used for supplying the
product is freely accessible.
for installation and
5