Renkforce RF100 Kurzanleitung Seite 3

Quick-Start-Guide
RF100 3D printer fully-assembled
Item no. 1507428
Delivery content
• 3D Printer fully-assembled
• 250 g Genuine renkforce filament
(1,75 mm, white)
• 8GB SD card with Cura software,
100+ printable 3D Model files
• Power cable
• Quick-Start-Guide (in German, English)
• Filament spool holder
• USB cable
Detailed Operating Instructions
Download the detailed operating instructions at www.conrad.com/downloads
or scan the QR code shown. Follow the instructions on the website.
Product picture
• Scraper
• Tweezers
• Side cutter
• Hex key with 2 screws
• Glass Build Bed preinstalled with
adhesive surface
• 3 x Genuine renkforce filament samples
(copper, wood and elastic material
- 1.75 mm - 50 g each)
Accessories setup
1
• Place build bed.
3
• Insert SD card with sticker facing
downwards.
5
• Plug the power cable and switch the
printer on.
Build bed calibration
1
• Press the knob to enter "Prepare"
menu.
3
• Adjust 3 screws under build bed to
adjust the gap between build bed and
nozzle until built plate is lying flat.
• Gap distance should be approx. 0.3
mm (i.e. use a piece of A4 paper as a
measurement tool). Nozzle must not
touch build plate!
2
• Use two screws and tool provided to
install spool holder.
"Nose" at the end of the holder faces
upwards.
4
• Cut the cable tie on each side with the
side cutter.
6
• "Info screen" appears on the display.
The printer is ready.
2
• Choose "Auto home".
4
• In "Prepare" menu, choose first "Level
Bed", then"First point".
• Repeat STEP 3 to adjust the distance
between nozzle and built plate.