Lake People DIGI-TOOL F610 Bedienungsanleitung Seite 16

THE AES-id INPUT
The input is situated on the back panel and
appears as a BNC connector.
It is marked "DIG IN".
The input is made according to AES-3id-2001
specifications, unbalanced, impedance 75
ohms, sensitivity 200 mV at Tnom/2.
A signal present at the "DIG IN" input is
displayed by the "MODULE INPUT ACTIVE"
LED on the frontpanel.
THE INPUT AMPLIFIER
The input signal is fed to a fast amplifier which
is capable to drive even weak signals to the
internal TTL level.
The signals are processed without alteration
of digital audio- or channel status data !!
AES-id SPLITTER MODULE
16
THE SYNC OPTION
When the "SYNC OPTION" module is present,
a valid AES-Sync Signal, fed from the option
module, is always processed with priority. This
will be displayed by the "OPTION INPUT
ACTIVE" LED.
The absence of input signals – and for this
reason no output signal – is displayed by the
"NO INPUT SIGNAL" LED.
THE AES-id OUTPUTS
Eight ouputs are situated on the back panel of
the case. They are denoted as "DIG OUT 1 / 2
/ 3 / 4 / 5 / 6 / 7 / 8" and equipped with BNC
connectors.
The outputs offer appropriate drivers and meet
AES 3-id-2001 specifications, unbalanced,
impedance 75 ohms, output level > 1 Vss.
(if this Modul is present)