Before Starting The Equipment; Operation; Replacing The Power Cable - EINHELL BT-MX 1400 E Bedienungsanleitung

Anleitung BT-MX_1400E_SPK1:_
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level 84,5 dB(A)
pA
K uncertainty
pA
L sound power level 95,5 dB(A)
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Mixing of paint and mortar
Vibration emission value a = 2.92 m/s 2
h
K uncertainty = 1.5 m/s 2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
Mixer assembly (Fig. 2):
First scew mixer part (6a) together with mixer part
(6b). Screw the mixer (6) into the mixer holder (5)
afterwards. Use the two spanners to do this. Use one
of the spanners (a) to hold the mixer holder (5) in
place and then use the second spanner (b) to tighten
up the mixer (6). Proceed in the reverse sequence to
undo the mixer.
is secure (pull the mains plug).
20.01.2009 15:02 Uhr

6. Operation

6.1 ON/OFF switch (Fig. 3/Item 1)
First fit a suitable mixing tool to the equipment
(see 5.)
Connect the mains plug to a suitable socket.
3 dB
To switch on:
Press the ON/OFF switch (1)
3 dB
Continuous operation:
Secure the ON/OFF switch (1) with the locking
button (2).
To switch off:
Press the ON/OFF switch (1) briefly.
6.2 Adjusting the speed (Fig. 1/Item 3)
Use the speed control (3) to pre-select the speed.
6.6 Changing over from 1st gear to 2nd gear
(Fig. 4 / Item 4)
You can work at a higher or lower speed depending
on the position of the selector switch. To avoid
damaging the gear unit you should only change over
gears when the tool has stopped.

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
Seite 13
GB
13