Conino Lamborghini TAS 2420 Originalbetriebsanleitung Seite 27

GB | Operating Instructions
effect is greatest there. Therefore, always apply the saw
as flatly as possible.
Avoid recoil! (Abb.17)
Recoil can occur when the running saw chain on the top
quarter of the guide rail strikes a fixed object or jams
(Fig. 17).
Pulling in! (Abb.18)
If the chain suddenly becomes stuck, jammed or strikes
a foreign object in the wood, the saw will be pulled for-
wards into the wood with a jerk (Fig. 18).
Avoid kickback! (Abb.19)
Kickback occurs when the chain suddenly becomes
stuck on the top of the rail, because it is jammed or has
struck a foreign object in the wood. The chain can then
jerk the saw back against the user (Fig. 19).
Attention!
• Always make sure that the chain tension is correct!
• Only use properly functioning chainsaws!
• Only work with a saw chain sharpened according to
regulations!
• Never saw with the upper edge or tip of the guide bar!
• Always hold the chainsaw firmly with two hands!
Sawing wood under tension
Sawing wood which is under tension necessitates ele-
vated caution! Wood that is under tension and is then
released from that tension when cut occasionally reacts
in a completely uncontrolled manner. This can result in
severe to deadly injuries. Such work may only be perfor-
med by trained specialists.
8