WimTec SanTec PROOF P4 Montage- Und Bedienungsanleitung Seite 21

Assembly: mains operation version
7
10
!
ATTENTION!
Perform the following steps
in the order indicated!
PROOF P4
8
11
7.
Feed the connection cable into the installation space and
connect it to the power supply (art. no. 117 899 for 1 con-
trol or art. no. 113 792 for up to 5 controls).
Attention: The power must be switched off, and the
power supply must not be installed in the shower panel
or the protected zone!
8. Configure the desired functions using the electronics
module (see p. 16).
9. Hook the shower panel into the front bracket strap.
10.
Connect the flexible tubes and included valves to the
water inlets.
11. Connect the power cables to the electronics module and
turn on the power (causing the safety locking mechanism
of the magnetic valve to activate).
9
- +
SanTec PROOF P4
Shower paneel
EN
Art.Nr. 121 018
21