Reprogramming - Solamagic S1 Montage- Und Gebrauchsanleitung

Reprogrammation
Selective deletion:
Already programmed radiant heaters can be deleted and reprogrammed
using the corresponding hand-held transmitter.
To do this press and hold buttons 1 and 2 of the hand-held transmitter
simultaneously (longer than 3 seconds) until the control lamp on the
hand-held transmitter illuminates. Deletion is now enabled. Now release the
buttons and directly thereafter briefly press that button with which the
radio receiver was operated up until now.
The control lamp on the hand-held transmitter flickers off briefly when the
deletion signal is sent. The radiant heaters enter an on-state and then switch
off and on again.
These receivers can now be reprogrammed as described under „Program-
ming" above.
Complete deletion:
Note: this action deletes all receivers that are within range
of the hand-held transmitter.
Programmed radiant heaters can also be deleted (reset) upon loss of a
hand-held transmitter or if it becomes defective.
The deletion process is only possible within 180 seconds of connection
to the mains of the radiant heater in question. (If necessary, disconnect
the radiant heater from the mains and then reconnect.)
To delete, hold buttons 1 and 2 of the hand-held transmitter pressed down
(longer than 3 seconds). When doing so, the red control lamp on the
hand-held transmitter only illuminates once deletion is enabled. Now release
the buttons and directly thereafter briefly press both buttons
simultaneously.
01/2015
80