Programming - Solamagic S1 Montage- Und Gebrauchsanleitung

Only those radiant heaters should be connected to the mains that are
to undergo programming to a hand-held transmitter button. In this
way several receivers can be programmed for simultaneous opera-
tion (multipower). Already programmed radiant heaters can remain
connected to the mains.
The radiant heaters to be programmed are connected to the mains.
Readiness for automatic programming (autoleaning) is signalled by full heat
output. Now brief pressing of the desired button on the hand-held
transmitter triggers radio receiver programming (low heat output). Repeated
pressing of the same button confirms the programming (full heat output).
This process is ended by final long pressing of a button on the hand-held
transmitter (briefly low heat output, then full heat output). The radiant heat-
ers are now programmed.
It is possible to program radiant heaters on up to eight buttons on one
or more hand-held transmitters (multicontrol). The corresponding radiant
heaters are connected to the mains (full heat output). As described under
„First programming", the button to be programmed is briefly pressed (low
heat output) and confirmed through repeated pressing (full heat output).
Then the next button is programmed by pressing (low heat output) and
subsequent confirmation (full heat output). This process is repeated until all
the desired buttons on all the desired hand-held transmitters are
programmed. The multiple programming is ended by long pressing of a
button on one hand-held transmitter (briefly low heat output, then full heat
output).
The radiant heaters remain completely off after a power outage.

Programming

79
:Important
:First programming
:Multiple programming
:Safety switch-off
01/2015