Operation; Switching On And Off; Device Adjustments; Practical Tips - Grizzly EFB 402 Originalbetriebsanleitung

GB

Operation

Caution, risk of Injury!
Always check whether the de-
vice functions correctly before
using it.
Always wear eye protection
when operating the device.
Always unplug the device before
working on it. There is a risk of
injury.
Observe the noise protection and
other local regulations. .

Switching ON and OFF

1. Loop the end of the extension
cable and hang it onto the cable
tension relief (5) to ease the ten-
sion on the cable.
2. Plug the tool into the mains.
3. To turn on, use your thumb to
actuate the switch lock (4), then
press the On/Off switch (2). Re-
lease the switch lock.
4. To turn off, release the On/Off
switch (2). There is no continu-
ous operation mode.
The brush will keep rotating for a
few seconds after the device has
been switched off. Keep the brush
away from hands and feet.
Do not try to lock the on/off
switch in place. Do not use the
device if the switch is damaged.
A damaged switch may cause an
injury risk due to the motor not
being switched off after releas-
ing the on/off switch.
22

Device adjustments

Length adjustment:
The telescopic arm enables you to adjust
the device to your individual height.
Unfasten the screw socket (7). Adjust

the telescopic arm (8) to the desired
length and re-fasten the screw socket.

Practical tips

Caution, risk of Injury!
• Always inspect the brush before
starting the device. Never use
damaged brushes. Replace any
damaged or worn brush.
• Use original brushes only.
• Never operate the device in rain
or on wet ground. Operating the
device in rain or on wet ground
can cause an electric shock.
• Always move across the slope
when working on hills.
• Avoid any contact with fixed
obstacles (rocks, walls, picket
fences, etc.) in order to prevent
damages to the device.
• Switch off the device during
breaks or when transporting it
and wait until the brush has com-
pletely stopped rotating.
Using the device:
Never move the brush across tile,
wood, plastic or other flooring mate-
rial. The brushes could scratch or
damage the surface. We do not as-
sume any liability for damages in this
case.