83300911 G2.qxd
08.08.01
[$$$$08:00:00$$$$]
[AUTO$$$$$$MANUAL]
[$$$$08:00:00$$$$]
[MANUAL$$$$$$AUTO]
14:31
Seite 71
Plain text display
Motor circuit 1 of UNI 22 is in the automatic
mode, motor circuit 2 is in the manual mode. For
motor circuit 1, all sensors are considered. For
motor circuit 2, only wind speed threshold value
and rain sensor are considered.
Motor circuit 1 of UNI 22 is in the manual mode,
motor circuit 2 is in the automatic mode. For
motor circuit 1, wind speed threshold value and
rain sensor are considered. For motor circuit 2,
all sensors are considered.
- 71 -
Plain text display
Depending on the sensor values, the following messages are
displayed in the automatic operation:
[$$TEMPERATURE$$$]
[$$DELAY$ACTIVE$$]
[$$TEMPERATURE$$$]
[$$$$TOO$LOW$$$$$]
[$SUN$DOWN$DELAY$]
[$$$$$ACTIVE$$$$$]
[$$SUN$UP$DELAY$$]
[$$$$$ACTIVE$$$$$]
[$SUN$INTENSITY$$]
[$$$$TOO$LOW$$$$$]
[$$CLOCK$MANUAL$$]
[$$$$$ACTIVE$$$$$]
G
G
The temperature is below the value set by the
room thermostat and the temperature reset delay
has not elapsed.
The temperature is below the value set by the
room thermostat and the temperature reset delay
has elapsed.
The preset sun threshold value is exceeded, the
sun response delay has not elapsed.
The preset sun threshold value is exceeded, the
sun response delay has not elapsed.
The preset sun threshold value is undershot.
The time control is activated, i.e. no automatic
travel commands will be executed until the end of
the preset time period.
- 72 -