Interfacing; Introduction; C 518 M; C 518 Ml - AKG MicroMic C518 M Bedienungsanleitung

The C 518 M/C 518 ML is a condenser micro-
phone and therefore needs a power supply.
Using any power supply other than those
recommended by AKG may damage your
microphone and will void the warranty.
1. Use the supplied connecting cable to connect
the output socket (5) on the gooseneck to a
balanced XLR microphone input with phantom
power.
2. Switch the phantom power on. (Refer to the in-
struction manual of the unit to which you con-
nected your microphone.)
1. Use the supplied connecting cable to connect
the output socket (4) on the gooseneck to one
of the two mini XLR sockets on the B 29 L or
the mini XLR socket on the connecting cable of
the MPA V L.
The connector will lock automatically.
• To disconnect the cable, press the unlocking
button on the mini XLR connector (1) and pull
the connector (1) out of the socket.
• To avoid damaging the cable, never pull
at the cable itself!
2. B 29 L: Connect the B 29 L to the desired input.
MPA V L: Connect the MPA V L to a balanced
XLR microphone input with phantom power
and switch the phantom power on.
AKG C 518 M / C 518 ML

2 Interfacing

2.1 Introduction

Important!

2.2 C 518 M

Refer to fig. 1.

2.3 C 518 ML

2.3.1 B 29 L
or MPA V L
Disconnecting
the cable:
Important!
15