Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

3.
Operators must be fully trained in the use of the machine
in accordance
with these instructions,
able to perform
regular user maintenance
and the correct selection
of
accessories.
4.
Operators
should be physically
capable to manoeuvre,
transport and operate the machines.
5.
Operators should be able to recognise unusual operation
of the machine and report any problems.
6.
Only genuine accessories
and spare parts provided with
the machine
or those
approved
by the manufacturer
should
be used.
All repairs must be performed
by a
qualified service agent.
7.
Do not use without filters in place.
8.
Do not modify the machine from its original design.
9.
Only use the machine on firm level surfaces.
DO NOT
use on a gradient or more than 2% slopes.
10. DO NOT use on rough uneven surfaces e.g. industrial or
coarse concrete surfaces.
11. DO NOT use outdoors e.g. on patios, decks or rough
surface.
12. WARNING Do not fill machines with water hotter than
40
Q
C
13. DO NOT use diesel/petrol or corrosive detergents to
wash floors, even if diluted.
14. This machine is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the machine by a person responsible
for their safety.
15. Keep children and unauthorised persons away from the
machine when in use. Do not use as a toy.
16. The machine must be kept clean and in good condition
with regular inspections of the battery charging lead and
plug for signs of any damage. If any parts are damaged
they shall only be replaced by an approved part by the
manufacturer, its service agent or a similar qualified
person in order to avoid a hazard.
ELECTRICAL HAZARD
17. CAUTION - This machine is for dry indoor use only and
should not be used or stored outdoors in wet conditions.
18. DO NOT use where hazardous dust is present.
19. DO NOT use in an explosive atmosphere.
20. DO NOT pick up or use near flammable or combustible
fluids, hazardous dusts or vapours.
21. CAUTION - If it is suspected that there is hazardous dust
or
flammable
materials
stop
cleaning
the
area
immediately and consult your superior.
22. DO NOT use to clean up any burning or lighted materials
such as cigarettes, matches, ashes or other combustible
objects.
23. Take care when using a machine near the top of stairs to
avoid overbalancing.
24. DO NOT put any object into openings. DO NOT use with
any opening blocked; keep free of dust, debris and
anything that may reduce airflow.
25. DO NOT cover the machine when in use.
26. Keep hair, loose clothing, hands, feet and all other parts
of the body away from openings and moving parts.
27. DO NOT use if it has been damaged, left outdoors or
dropped in water.
28. DO NOT run the machine dry, as this could damage the
floor surface or the machine itself.
29. Never use excessive foaming or highly corrosive
cleaning solutions.
30. Do not operate the machine with a damaged supply lead
or plug, or after the machine malfunctions or is damaged
in any way. Contact an authorised Service Agent for
repair or adjustment.
31. Only replace the supply cord with the type specified in
the instruction manual.
3
32. This machine should always be connected to a fully
earthed power supply of the right voltage and frequency.
33. DO NOT leave machine running unattended.
34. Do not leave the machine connected to the electricity
supply when not in use, always remove the plug from the
socket-outlet.
35. Switch off the machine before removing the plug.
36. When unplugging, pull the plug, not the supply cord.
37. The machine shall be disconnected from its power
source when not in use and before commencing cleaning
of the machine or maintenance and when replacing parts
or accessories, by removing the plug from the socket-
outlet.
38. DO NOT pull or carry by the supply cord. DO NOT use
cord as a handle, close door on cord or pull cord around
sharp edges or corners.
39. WARNING: Keep the supply cord clear of moving parts.
40. DO NOT kink or twist the supply cord and keep cord
away from heated surfaces.
41. DO NOT operate switches or touch the mains plug with
wet hands as this may cause electric shock.
42. The power supply cord plus any extension leads should
not exceed 30 metres in total. The cross section of an
extension cable wiring must be at least 2.5mm
2.
CONTROLS ON THE MACHINE
The operating controls are located on the handle and on the
side of the machine. Please refer to page 1.
1. Solution discharge handle
6. Main brush
2. Solution tank
7. Motor overload button
3. Recovery tank
8. Pedal
4. Lid cap
9. Transport/workinq mode
5. Nozzle
10. Brush pressure
Transporting the machine
Incorrect lifting techniques may result in personal injury. We
advise that the manual handling regulations are followed. Do
not expose the machine to rain or moisture.
When transporting the machine ensure that all components,
tanks and removable parts are securely fastened, and that
the supply cord and plug are not trailing.
When transporting the machine the handle should be locked
in the upright position.
Take extreme care when moving the machine up or down
steps or stairs.
Brush Identification
Red, Blue, White and Yellow brush buttons are packed with
the machine. Simply plug the buttons into the hole in the
brush as shown. Clear identification, by colour coding, helps
prevent cross contamination.
Storage
• Always switch off, empty, wipe down and dry the machine
after use.
• Both the solution and recovery tanks should be emptied
and flushed out with clean water to ensure the seals and
pumps are free from any cleaning detergents.
• Wrap the supply cord around the cable winder ensuring
that the plug is not trailing on the floor.
• Store the machine in a dry indoor area only.
Maintenance
&
WARNING - Before undertaking
maintenance
!
operations or adjustments switch off machine
and
unplug
from
the
electricity
supply.
IMPORTANT - All other servicing and repairs should only be
performed by a Truvox engineer or Authorised Service
Agent. IMPORTANT - Should the machine fail to operate
please refer to the fault diagnosis section in the back of this
instruction manual. If the problem / remedy is not listed

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Multiwash mw340 pumpMultiwash mw340Multiwash m440 pump

Inhaltsverzeichnis