Maintenance - Axair PH14 Bedienungsanleitung

Maintenance

Your appliance can only provide full hu-
midification and purification performan-
ce if it is regularly cleaned and if neces-
sary the filters respectively the evapora-
tor mat are replaced. Use only a damp
cloth (no scouring or etching agents) to
clean the outside of the appliance. The
cleaning interval is greatly dependent
on the operating location. The filters must
often be changed when the room air is
heavily contaminated The wet compo-
nents must often be cleaned if the water
is very hard.
• Clean these components:
Coarse filter – Coarse dust filter or
Quattro filter – Mobile base – Interme-
diate floor – Water basin – Droplet
trap – Flock-coated evaporator mat or
Activated carbon evaporator mat
• Replace these components:
Coarse filter – Coarse dust filter or
Quattro filter – Flock-coated evapora-
tor mat or Activated carbon evapora-
tor mat
Attention! Before starting the mainte-
nance, disconnect the unit from the pow-
er supply.
Fig. 1 First withdraw the mains plug
and place a cloth on the floor under the
wheeled water carriage.
Remove the water carriage.
Fig. 2 Press in the two latches at the
bottom of the appliance. If the appli-
ance always remains at the same loca-
tion, the latches can remain open (they
are used only as transport fasteners).
Fig. 3 Lift off the housing.
Bild 4 Lift off the coarse dust filter or
Quattro filter and the mobile base cover.
Make sure that the coarse dust filter or
Quattro filter does not become wet.
Fig. 5 PH14A: Empty the water basin
with the supplied pump.
Fig. 6 Lift both retainers.
Press the evaporator mat together and
pull it out.
18
1 2 3 4
1
3
5
5 6 7 8 9
2
4
6
Months
10 11 12