Appliance Operation - Axair PH14 Bedienungsanleitung

Appliance operation

Control buttons
All button functions at a glance:
• Press the ON/OFF button.
Select the level (I, II or III) that corre-
sponds to the conditions of your room
(see technical data on page 21).
• When operating the appliance for the
first time, press the two "R" buttons
simultaneously for at least 3 seconds.
Read the relative humidity of the
room air (actual value)
• Press the rH% button.
Set reference value
We recommend a relative humidity of
45% for living areas.
• Press the plus button or the minus button
to increase or decrease the reference
value.
If the appliance has been out of service
for a considerable period of time, it takes
about 30 minutes before the exact value
of the room relative humidity can be dis-
played. The display is switched off when
the wheeled water carriage is removed.
After reactivation, the exact relative hu-
midity of the room is displayed after about
1 minute.
40 45
To lock the setting:
• Press these two buttons simultane-
ously for a minimum of 3 seconds.
Alle settings are locked (on/off
incl.). Unlock the setting in the
same manner.
rH% 40 45
Actual value
R R
R
rH%
R
rH%
The "water low" display blinks when
the PH14 is used as an air purifier
without water.
• The water low display can be
switched off by pressing these two
buttons simultaneously for at least
3 seconds.The display is again
ready for operation as soon as the
appliance is refilled with water.
Reference value
45
R
R
17