SuperFish PondECO Plus E 3500 Gebrauchsanweisung Seite 3

Usage
• Cut the hose connector to the desired
diameter and fasten this to the pump.
• Connect the pond hose to the hose
connector using a hose clamp (not
supplied).
• Install the pump in your pond at least
20 cm below the surface of the water.
Make sure that the pump is seated
firmly.
• When used inline, outside of the pond;
make sure the pump gets enough
water supply and does not run dry,
make sure all connections are 100%
waterproof, leakage may lead to an
empty pond and cause harm to your
fish and plants.
• Never lift the pump out of the water by pulling the power cord.
• Remove the pump from your pond during frosty periods and clean it well and store it in
a dry place free from frost.
• Your pump needs regular cleaning, see page 10!
• There is no warranty on failures due to dirty pumps and scale build up inside the pump
caused by improper maintenance.
• Depending on usage the rotor of your pump can get worn out and damaged, this is
normal, new rotors can be purchased at your dealer.
Technical data
PondECO Plus E 3500
Voltage 220-240 V/50 Hz 220-240 V/50 Hz 220-240 V/50 Hz 220-240 V/50 Hz 220-240 V/50 Hz 220-240 V/50 Hz
Power 14 W
Capacity 3,500 l/h
Max. head of water 2.00 m
Connection 40/32/25 mm
Cable length 10 m
5000 8000
22 W 41 W
5,000 l/h 7,800 l/h
3.00 m 4.20 m
40/32/25 mm 40/32/25 mm
10 m 10 m
10000 12000
68 W 85 W
9,200 l/h 11,200 l/h
5.80 m 6.00 m
40/32/25 mm 40/32/25 mm
10 m 10 m
15000
130 W
15,000 l/h
6.50 m
50/40 mm
10 m
3